cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
412
Views
0
Helpful
1
Replies

Unable to delete 'storm-control' statements from an interface

stuartkendrick
Level 1
Level 1

BRIEF
- I would like to clear all configuration statements from an Ethernet interface on an N9K (93180YC-EX), including the (4) storm-control ones. But, I am unable to do so: "Invalid command"


DETAIL
N9K# sh run int eth1/47

version 7.0(3)I7(9) Bios:version 07.66

interface Ethernet1/47
storm-control broadcast level 1.00
storm-control multicast level 1.00
storm-control action shutdown
storm-control action trap

N9K# config t
Enter configuration commands, one per line. End with CNTL/Z.
N9K(config)# int eth1/47
N9K(config-if)# no storm-control broadcast level 1.00
^
% Invalid command at '^' marker.
N9K(config-if)#


N9K(config-if)# default interface Eth1/47
N9K(config)# sh run int eth1/47

!Command: show running-config interface Ethernet1/47
!Running configuration last done at: Tue Jul 26 03:14:38 2022
!Time: Tue Jul 26 03:14:41 2022

version 7.0(3)I7(9) Bios:version 07.66

interface Ethernet1/47
storm-control broadcast level 1.00
storm-control multicast level 1.00
storm-control action shutdown
storm-control action trap

N9K(config)#

 

Suggestions for a next step in trouble-shooting?

--sk

Stuart KendrickNex

1 Reply 1

Kewal Agarwal
Cisco Employee
Cisco Employee

Hello Stuart,

Have you tried just 'no-storm control'?

Another way to reset the configuration is using 'default interface eth1/47' in the global configuration mode- However this will reset the entire interface configuration, so make sure do it in a maintenance window.

Thanks,

KA

Review Cisco Networking for a $25 gift card