DevNet General Discussions

how to connect to webex meeting through link with react code?I have a webex meeting link and i want to join meeting with my website in react.

I made the script that using Cisco support APIs.The script was worked.However, This script works in the following order. 1, Get Access TokenGet Support InformationFinishedI think this script would be better behaved with a revoke at the end.Because I ...

When using the Nexus V9P SmartNIC with a cusgonm FPGA load, the RX counters, TX counters and dropped packet counters do not match between OS ifconfig and exanic-config. we are using libexanic in a custom application to read packets. How does the OS/i...

Good day!I am developing highly explosion-proof equipment using ESS-3300- (24T) -CON-E switches.The switch will be used at category mines.The hardware technical guide has a link to Reference Design for correct product design.For example, the features...

Hi Team,   while adding new network device via POST to the DNAC sandbox , Response received as below. please advice how to resolve the Issue {'message': 'Role does not have valid permissions to access the API'}   please check sample code below. token...

Hi to all, i want to use a cisco touch 10 device to control some crestron devices. For most commands we use the touch 10 module available via Cisco Touch 10 Room Control v1.0 - Crestron Application Market in addition to some widgets (Buttons and Text...

Note: I'm not sure this is the right place for new feature suggestions; let me know if I should move it. Feature Suggestion:A "BRB" (Be Right Back) indicator in Webex meetings to indicate the brief unavailability of an attendee.  Use case:Meeting att...

Meraki has a "Scanning API" ( https://developer.cisco.com/meraki/scanning-api/ ), which allows a developer to subscribe to location/rtls/rssi feeds of clients, allowing 3rd parties to develop an RTLS solution. Is there an equivalent API/feed for Cata...

Hi,OID snmpI'm looking for the correct SNMP OID (MIB) to set a port's speed and duplex mode remotely. I only found things like ".1.3.6.1.2.1.2.2.1.5.49" and ".1.3.6.1.2.1.10.7.2.1.20.49" , but it says that it's "Read Only" so I can't set it using SNM...

Hi All, I have been reading up on pyats and would like to know how to create a topology file as a dict like {'hostname':'ip"} instead of the yaml file shown in the examples. The reason why I want to go with that method is becuase I am trying to conne...

We can't fetch more than 3000 users using /list-people and pagination API due to API limitation.https://developer.webex.com/docs/api/v1/people/list-people Is there any workaround which returns users beyond limit 3000 using any API request?