Resolved! CUCM Sandbox - Internet Access
Do the CUCM sandbox environments have internet access? I am attempting to setup a CDR Billing Server to a public IP address to test CDR transfer settings. Thank you.
Forum Posts
Can 4 additional VPN sessions be added to my Sandbox? Sandbox ID is 536c4c0c-9d53-4ab0-9ef6-dad00d6ae502 Thank you
Resolved! AnyConnect timeout failure
Help requested; while I could connect last week all this week I'm getting timeout failures. While I can reach the sandbox, and I can get the DNS entry for 173.38.221.89 but can't ping it and AC times out. Rebooted, removed and re-installed AC but n...
Successfully uninstalled pip-21.1.1pip3.9 install ncclientRequirement already satisfied python3.9 NC-get-config.py --host ios-xe-mgmt.cisco.com -u developer -p C1sco12345 --port 10000ModuleNotFoundError: No module named 'ncclient'
I reserved a sandbox this morning and connected to the VPN. After it updated AnyConnect to 4.9.04043 and reconnected, I cannot reach any hosts in the Secured Routes list. Found that I couldn't resolve DNS when I connected so I started pinging all t...
I created a new on demand session about 11:00 AM CST today. The setup took a bit longer than I was used to but it finally completed. Once completed I received the standard email stating to login to the VPN which I completed fine. Once logged into the...
I setup a reservation for Unitied Contact Center Express 12.5 w/ Finesse and typically I receive two e-mails after I request the reservation. The first one stating the environment is being built, while I receive a 2nd one after it has been built wit...
HiWhile creating sandbox lab getting following error13:41:28 Clear POD ARP Cache FAILED13:41:31 Enabling VPN Connections for POD 240, VLAN 34013:41:43 ERROR: Errors encountered provisioning VPN sessions.
I get errors when trying to reserve Unified Contact Center Express 12.0 Sandbox. I cannot use it. 09:34:26 Environment Driver Setup has begunBeginning sandbox setupPreparing connectivityApps deployment startedApps are being discovered...Connecting al...
Hello, When trying the Reservation in the Devnet Sandbox i get the following error: 10:16:57 configuring ncs...10:17:19 Completed Setup for resource [NSO_d93c-db51]10:17:29 Clear POD ARP Cache FAILED10:17:32 Enabling VPN Connections for POD 129, VLAN...
After I installed Sandbox AnyConnect, I found that my wireless can’t be used, I can only use wired ones. Does the software Sandbox AnyConnect conflict with my wireless?
I clicked on the link to the lab in my email and I receive the message: NO SANDBOX FOUND.
When I do virl ls --all I get this. Nothing else shows up and no nodes. (venv) [developer@devbox ~]$virl ls --allRunning Simulations╒══════════════╤══════════╤════════════════════════════╤═══════════╕│ Simulation │ Status │ Launched │ Expires │╞══...
Hello, When I download my lab file from cml the desktop computers from my lab does not save the eth0 static ip address, netmask or gateway.Is there a way to save it? Or write it yourself in the yaml file downloaded form the lab? This is the configur...
Hi team, Link to the Sandbox:https://devnetsandbox.cisco.com/RM/Diagram/Index/be51af73-c9e9-4af7-89d2-42c1c71e1f09?diagramType=Topology I logged into the devbox: 10.10.20.50SSH access to the DevBox 10.10.20.50 server using credentials developer/cisco...
