03-03-2024 09:17 AM
I keep getting an error " There was an error processing your request' while trying to launch the "IOS-XR Programmability Always-on sandbox"
03-03-2024 10:57 AM
This message appears on always on sandbox as technical no reservation is actually required. On the instructions of the sandbox of the screen expand the options in the “additional information” and follow the sandbox domain name/IP address and username/password.
Hope this helps.
03-04-2024 12:33 PM
Thanks for your reply. However, i did not receive any email with the Anyconnect VPN/Login details. I only get this email and nothing after that.. I waited for about 30 minutes... See the email below:
Hi Janmesh Jani,
We are currently setting up your IOS XR Programmabilty AlwaysOn Lab, which will take approximately 1 minutes.
We know you are anxious to get in there and start doing great things, but we need a little more time to stitch it all together and run a few tests.
In the meantime, here’s what you can expect:
When your sandbox is ready you will receive an email with your lab’s access credentials and instructions on how to connect.
If there are any issues setting up your sandbox you will receive an email with details and next steps.
Note: If you do not have the Cisco AnyConnect Secure Mobility Client installed on your system you should do that now. It is required to access devices in your Lab.
--The DevNet Sandbox Team
03-04-2024 01:07 PM
That’s correct. There is no VPN requirement for the always on sandbox. You can access these directly over any internet connection.
Hope this helps.
03-04-2024 06:39 PM
Hi.. Thanks for responding.. i really appreciate your help...
Yes you are right... I am able to access 1 node... But what actually i am trying to do is follow the instructions here on "IOS-XR Streaming Telemetry " lab ... It says i need a VPN connection and i will have access to the 3 devices listed
not sure if you have access to this.. I think this will give you better idea what i am trying to do...
03-05-2024 01:54 AM
Ok i see the issue you are having. The sandbox being referenced is not in the catalog anymore as far as i can see, and the only XR sandbox is the one you mentioned is the 'always on' which would not be able to run the lab you are using for number of reasons. The devnet team will need to update the lab, remove the lab or advise when/if the sandbox will be placed back into the available catalog.
Hope this helps.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide