Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi guys,IR 809 fails to boot properly if the USB storage is inserted during power up. Boot stucks in rommon-1> and there's no way to make it run. I tried to bootHV from the usb drive but this failed as well. If I try to dir there are some errormessag...
HiI wanted to use IOx debug commands to see why my GOS is not starting. I entered "debug iox", as shown below, and then tried to start the GOS. The GOS is not starting, as shown by the result of the "show iox host list detail" command, but nor do I s...
It seems to me that there would be a larger need for IOx based network nodes that ran on non rugged enterprise environment, like the 3560, 3850, etc. I find that there would be a large use case for creating apps living in these environments where the...
HiI would like to create my own Yocto image tor test purposes, especially with LXC containers.I can use the Yocto Quick Start and the Yocto Build Appliance.When running the build appliance, which is a menu driven system for creating images, I can cho...
My IR829 and IR809 devices did not arrive with power adaptors, so I created my own and wrote that up here:https://github.com/DevOps4Networks/IOX-Notes/tree/master/How_To_Power_UpSince then, I received two PWR-60W-AC-V2= power supples from Cisco that ...
HiThe attached configuration is an attempt to create a DHCP pool from which I can assign addresses both to the GE1-4 switch interfaces and the GOS.The outcome of applying this configuration is as expected for all aspects, except for the address assig...
HelloI am trying to measure the temperatue with TEMPer USB Thermometer, using 1 USB port on my CGR1120. This port is mapped to the GOS and device is correctly discovered with dmesg. As a next step, I have found that it can be used in Linux, using lib...
HiIn the SDK 1.0, there is a tutorials/apps/Makefile that looks like it should build all of of the apps in the same directory.In that Makefile there is a requirement for the IOX_YOCTO_PROJECT_DIR variable to be defined.That variable does not seem to ...
I want to install other OS on ioX , rather than supplied yocto linux. Is that possible? I could not find any doc on it, even though the IoX docs make a general statement that the hypervisor arch can host any OS.
Hello --My company has developed it's own radio card to go inside the CGR1240. We are using IoX and noticed that we need increased flexibility in setting a few key exchange settings. key-exchange timeout-hardcoded to 10sec => we need to have it conf...
Hi,It seems that the following commands are not described in any on-line manual.hw-module assign x goshw-module third-party xCould anyone tell me any pointer ?Thanks,Shoichi
