Cisco ESA for Internal Mail.

[RohitDhiman5005]

Hello Guys,

Is it possible that Cisco ESA will scan the Internal/Local mails as well?

For example, Alan and Jack both are working for the same company xyz and their Exchange server domain is xyz.com.

Suppose Alan sent an email from his mail-id (alan@xyz.com) to Jack's email-id (jack@xyz.com), Is it any possible deployment of Cisco ESA so that ESA will scan these types of mail exchange?

As far as Design or Document says Cisco ESA is just a mail gateway it will only come in the picture if mail will be sent from one domain to another domain.

Regards

Rohit Dhiman

[marc.luescherFRE]

The current product line only allows for in- and/or outbound scanning in the most common use cases.

Some mail solutions allow you to define an out of bound gateway. Meaning that all outgoing SMTP traffic would always go to the mailgateway. In such a case this would work as the Ironport wold then again route the email to internal recipients.

Not a common use case.

-Marc

[RohitDhiman5005]

Hello Marc,

Thanks for your reply,

Which means we both are on the same page Cisco ESA will only scan mails if it will be sending from one domain to another different domain.

Regards

Rohit Dhiman

[Mathew Huynh]

Hey Rohit,

This can be done but not completely ideal.
As internal to internal emails should typically be trusted and on the exchange it will simply deliver directly into inbox.
However there are some instances of setups where ALL emails (regardless of internal to internal) has been sent into the ESA for filtering and sent back in (not ideal and not really necessary to be honest).

All of this is dependant on the Exchange / groupware server you're using.

Regards,
Mathew