- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-19-2021 05:24 AM - edited 11-19-2021 05:26 AM
Hi,
I'm planning to install 3 ESA C300V and i would know what interface will be used when enabling cluster with CCS ? Management, Data1, Data2 ?
Many thanks
regards
Solved! Go to Solution.
- Labels:
-
Email Security
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-19-2021 05:45 AM
In the same data center, I put the management interfaces on the same subnet and tell the boxes to connect to one another via the management ip.
In separate data centers I would put a route in for the management networks via the management interfaces default gateway.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-19-2021 05:58 AM
I prefer to use MGMT Interface each flat network of Manmangment (no Firewall involved between devices)
Look at the guide Lines and config :
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-19-2021 07:20 AM
thank you all.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-19-2021 05:45 AM
In the same data center, I put the management interfaces on the same subnet and tell the boxes to connect to one another via the management ip.
In separate data centers I would put a route in for the management networks via the management interfaces default gateway.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-19-2021 05:58 AM
I prefer to use MGMT Interface each flat network of Manmangment (no Firewall involved between devices)
Look at the guide Lines and config :
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-19-2021 07:20 AM
thank you all.
