Endpoint Security

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Cisco CyberSecurity

Forum Posts

Two recurring issues with version 8.0.1.211641. high memory usage on Windows 10 (several feature packs) and older OS2. the right click to Scan Now does not bring up the dialogue that shows the progress or results of the scan

acdwb by Level 1
  • 3803 Views
  • 5 replies
  • 0 Helpful votes

hello  we have 2  x ISE with certs due to expire 22nd September    we have installed 2  new certs  can I use Admin ->Certificates -> System Certs to disable the certs due to expire 22nd  to test the new certs  or is there a better way to test new cer...

sbyrne by Level 1
  • 419 Views
  • 0 replies
  • 0 Helpful votes

Hello.We are trying to configure DHCP snooping and IP source guard on our L2SW to perform dynamic IP address inspection.I have completed both configurations and the end node is able to get an address via DHCP.However, normal communication seems to be...

We recently attended a "test drive" class for Cisco AMP where they mentioned that AMP was approved by Microsoft as a 3rd party AV client that should disable windows defender. I've linked the KB below. We have several test machines with AMP deployed t...

JDoobs by Level 1
  • 29491 Views
  • 18 replies
  • 0 Helpful votes

When setting the conviction modes in the policy settings of a computer. Is there a guide on how each one affects performance of a computer? That way we know when turn them from disabled -> audit -> protect that it will have an impact on performance?

jbailey2 by Level 1
  • 831 Views
  • 2 replies
  • 0 Helpful votes

I created Cisco AMP for endpoints free trial version. I got a confirmation mail, but I did not get any account activation mail as mentioned in the guide https://www.cisco.com/c/en/us/products/collateral/security/amp-for-endpoints/guide-c07-744325.htm...

Screenshot 2022-08-23 at 10.19.26 AM.png Screenshot 2022-08-23 at 10.19.26 AM.png
ssrinidhi by Level 1
  • 613 Views
  • 0 replies
  • 0 Helpful votes

I have been running Secure Client for a week, and I got a notification that I don't currently have an Umbrella profile installed. I cannot figure out how you would create one though. I see a place to import a configuration, but I've poked around the ...

DevLop by Level 1
  • 5871 Views
  • 1 replies
  • 0 Helpful votes