03-14-2018 01:55 AM
Hi Team,
Good day!
This would be a generic question regarding a NEAT setup in the customer's environment. So as per the customer's requirement,
they would like to push a Native VLAN to the Trunk port on the Authenticator Switch. This is required as there is a Native VLAN
mismatch between the Supplicant and Authenticator Switch, which doesn't let the traffic through. From what I understood in trying
to set it up, I couldn't find any relevant document/article which said a Native VLAN could be pushed from ISE, but however would
like to confirm on the same. Any inputs or advices on the same would be very helpful.
Thank you!
Regards
Mohammed Nazeeh
Solved! Go to Solution.
03-15-2018 04:12 PM
03-15-2018 04:12 PM
05-03-2018 01:41 AM
Hi Hari,
Thank you for the response.
It was a doc which I never came across. That really did help me out.
Regards
Nazeeh
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide