03-26-2024 06:34 PM
Hi, I collect vintage Cisco networking equipment. I have a Cisco PIX 515E.I can't seem to reach the outside internet with it. Here is my config: RDXLFW1# sh ru
: Saved
:
PIX Version 7.2(2)
!
hostname RDXLFW1
enable password 8Ry2YjIyt7RRXU24 encrypted
names
!
interface Ethernet0
nameif outside
security-level 0
ip address 192.168.1.80 255.255.255.0
!
interface Ethernet1
nameif inside
security-level 100
ip address 10.0.0.1 255.255.255.0
!
interface Ethernet2
shutdown
no nameif
no security-level
no ip address
!
passwd 2KFQnbNIdI.2KYOU encrypted
ftp mode passive
pager lines 24
logging buffered debugging
mtu outside 1500
mtu inside 1500
icmp unreachable rate-limit 1 burst-size 1
no asdm history enable
arp timeout 14400
nat-control
global (outside) 1 192.168.1.81-192.168.1.135 netmask 255.255.255.0
global (outside) 1 192.168.1.51
nat (inside) 1 10.0.0.0 255.255.255.0
route outside 0.0.0.0 0.0.0.0 192.168.1.1 1
timeout xlate 3:00:00
timeout conn 1:00:00 half-closed 0:10:00 udp 0:02:00 icmp 0:00:02
timeout sunrpc 0:10:00 h323 0:05:00 h225 1:00:00 mgcp 0:05:00 mgcp-pat 0:05:00
timeout sip 0:30:00 sip_media 0:02:00 sip-invite 0:03:00 sip-disconnect 0:02:00
timeout uauth 0:05:00 absolute
no snmp-server location
no snmp-server contact
snmp-server enable traps snmp authentication linkup linkdown coldstart
telnet timeout 5
ssh timeout 5
console timeout 0
dhcpd address 10.0.0.10-10.0.0.110 inside
dhcpd enable inside
!
!
class-map inspection_default
match default-inspection-traffic
!
!
policy-map type inspect dns preset_dns_map
parameters
message-length maximum 512
policy-map global_policy
class inspection_default
inspect ftp
inspect h323 h225
inspect h323 ras
inspect netbios
inspect rsh
inspect rtsp
inspect skinny
inspect esmtp
inspect sqlnet
inspect sunrpc
inspect tftp
inspect sip
inspect xdmcp
!
service-policy global_policy global
prompt hostname context
Cryptochecksum:60f7cdd469e5a489e44e1759abedd3cb
: end
RDXLFW1#
03-30-2024 09:27 AM
Hello @RadxD461 ,
can you provide the output of the following commands after you try accessing the Internet:
show nat detail
show conn all
03-30-2024 09:32 AM
I figured out the issue. It was a DNS issue.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide