02-09-2021 05:41 AM
Hello All
I hope you're okay.
I applied an erase configuration from the local-mgmt interface and now I can't access the FTD, the system shows me that the Ftd has not installed.
I tried to follow the cisco links but it doesn't work
Also I tried to use the chassis management interface with https it doesn't work too (Login and Password) incorrect
Thank you in advance for your help
Regards.
Solved! Go to Solution.
03-02-2021 10:50 AM
Hello Peter
Yes I confirm its complicate with Cli.
But I was able to solve the access problem by adding this command at the scope seystem/services level.
/system/services # enter ip-block 0.0.0.0 0 https.
And finaly reimage the FTD with Gui.
Thx peter.
Regards.
02-09-2021 05:47 AM
what is the model ?
you can try below steps :
02-09-2021 06:37 AM
Hello Balaji
Thank so much for your return
The model is FPR 4110
I get the message Error: Update failed: [Application image not found. Please upload the application csp file.]
and on the package partition I only have the FXOS available.
sh-A /firmware* # show package
Name Version
--------------------------------------------- -------
fxos-k9.2.2.2.17.SPA 2.2(2.17)
sh-A /ssa* # sh app
Application:
Name Version Description Author Deploy Type CSP Type I
s Default App
---------- --------------- ----------- ---------- ----------- ------------ -
-------------
ftd 6.2.2.81 N/A cisco Native Application Y
Regards.
02-09-2021 06:43 AM
Hello
I downloaded again the application ftdftd 6.2.2.81 again but it's in down mode how to put it in enable mode ?
sh-A /ssa # show app-instance
App Name Slot ID Admin State Oper State Running Version Startup Versi
on Cluster State Cluster Role
---------- ---------- ----------- ---------------- --------------- -------------
-- --------------- ------------
ftd 1 Disabled Offline 6.2.2.81 6.2.2.81
Regards.
02-09-2021 07:10 AM
Hello
sh-A /ssa/logical-device # show detail
Logical Device:
Name: sh
Description:
Slot ID: 1
Mode: Standalone
Oper State: Incomplete Configuration
Template Name: ftd
Error Msg: Application ftd requires minimum 1 Mgmt interface(s) ------- how to configure it
Switch Configuration Status: Ok
Resource Profile Name:
Resource Profile DN:
Current Task:
03-02-2021 09:53 AM
It’s complicated on CLI. Get access to chassis management GUI. Try the default password.
03-02-2021 10:50 AM
Hello Peter
Yes I confirm its complicate with Cli.
But I was able to solve the access problem by adding this command at the scope seystem/services level.
/system/services # enter ip-block 0.0.0.0 0 https.
And finaly reimage the FTD with Gui.
Thx peter.
Regards.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: