Hello,
I have configured two 8961 phones, both registered to a CME router.
These phones share two same extension numbers.
The issue is both phones do not ring when I call any of the two number, only one phone rings.
Please refer the configuration below:
voice register dn 1
number 801
call-forward b2bua busy 811
call-forward b2bua noan 811 timeout 18
allow watch
name test1
label test1 - 801
!
voice register dn 2
number 802
call-forward b2bua busy 811
call-forward b2bua noan 811 timeout 18
allow watch
name test2
label test2 - 802
voice register pool 1
busy-trigger-per-button 6
id mac xxxx.aaaa.xxxx.aaaa
type 8961
number 1 dn 1
number 2 dn 2
no digit collect kpml
dtmf-relay sip-notify
username 801 password cisco
description xxxxxx
!
voice register pool 2
busy-trigger-per-button 6
id mac xxxx.bbbb.xxxx.bbbb
type 8961
number 1 dn 1
number 2 dn 2
no digit collect kpml
dtmf-relay sip-notify
username 802 password cisco
description xxxxxx
I want both phones to ring when either 801 or 802 is dialed.
Thank you.
Regards,
Abhi
