Analog port in SRST

[alex goshtaei]

Hi All,

I am using MGCP with CUCM 7.0. Should I configure "connection plar" under voice port configuration for analog ports FXO in SRST mode?

thanks

Alex

[Nicholas Matthews]

Hi Alex,

Yes. When the port is MGCP controlled it will be ignored.

hth,

nick

[andresfmg]

hi i have yhe same issue, i have a gateway srst and the ports are controled by the cucm with mgcp, every work just fine, but when then connection fails, and the router up the srst mode i can get anything , becouse the comandas connection plat under the ports, are not reconized becouse are in mgcp, ??there is any solution ???