ATA Remote Reboot

[Mitchel Erb]

Has anyone ever asked about adding a remote reboot option to ATAs?  Just curious...with them being power brick connected it would be nice to have a restart option in the UI(admin authentication required), this would lessen the possibilities of an end user at a remote location powering down the wrong piece of equipment.  We see that at times they need a kick, have IP connectivity but not registered to CM, a reboot resolves.  Thanks...

[Brandon Buffin]

I understand an option to restart was available from the GUI in earlier versions of firmware. Not exactly sure why it was removed? One workaround would be a network connected power outlet/PDU that would allow you to control power to the ATA. These are available at a fairly reasonable price.

Brandon