Block Called ID outgoing

[wilsonsant]

Hi Guys,

My Customer have the solution with CallManager 5.1.3 using the MGCP and would like blocked called ID for outgoing calls. My question is: Is It possible block in the CallManager 5.1.3 or only carrier can be blocked the Called ID outgoing? The additional information, the PSTN using the Primary QSig

Thanks,

Wilson

[Marwan ALshawi]

in nrmal cases you can block or mask the outgoing calling ID

yoiu can do it on the route pattren level, route list level or GW level

HTH

[wilsonsant]

Hi Marwanshawi,

Thank You for answer. My Customer would like that  in called number appear the message "know number". Could You pass more ddetails who to do this configuration in Route Pattern or Route List. Are there any documentation about this?

Thanks again,

Wilson

[iptuser55]

On the Route pattern you have Calling Line ID - Allowed, Default, Restricted- You can do it here

[wilsonsant]

Hi Guys,

I am sorry by delay. I changed the parameter in the Gateway, in the Route Pattern, but, didn´t work. The called number still to see the number of calling. Another have idea about this?

Thanks,

Wilson

[acampbell]

Wilson,

On the MGCP gateway --> endpoint

Look at the section for outbound calls

Change the Calling Party Presentation (Drop down) to "RESTRICTED"

This is last element for a call leaving CUCM/MGCP passes through.

Hope this helps

Regards

Alex

[wilsonsant]

Hi Alex,

I did had already this change configuration, but, didn´t worked.

Thanks,

Wilson

[iptuser55]

What number is being sent- could it be your Telco sending it  ?

[iptuser55]

what number is being sent- is it DDI/External Mask .

[wilsonsant]

Hi iptuser55,

The number that is sending is principal number, for example, the range the number is 5741-2000 until 5741-2999, It send the 5741-2000. Yes, I believe that the Telco is sending it.

Thanks,

Wilson

[iptuser55]

I think you need to tell the telco to restrict in that case