01-03-2008 01:25 PM - edited 03-15-2019 08:02 AM
Cisco IOS: 12.4(11)XW3
Hardware: 2811
I'm using cisco call manager express 4.2, i'm not able to get the caller ID from outbound calls to display on the local phones.
Were are using FXO cards (no pri). I ran the debug VPM signal command and the caller id of the number shows up correctly. (full debug attached)
from what I can tell the caller ID number is being received correctly just not showing up. I see that the caller-name is showing up blank maybe this is what the phones are trying to display? If thats correct is there any way to change it?
Any insight into the issue would be appreciated.
01-09-2008 11:03 AM
haha, yea I'm stumped i've worked on a few CME's UC500 and have never come across this.
Q. Do the 7910's show a calling number/name for internal calls?
A. Yep, Shows Caller Name for internal extensions.
Q: Log from debug ephone det mac-address & Test call.
A: Log has been attached.
I Replaced the real calling number with 619xxxxxxx.
To me it looks like the ephone is getting the number just not displaying it correctly. I see the calling number through-out the debug so I know its being received by the phone.
I've also tested a few of the 7910s and results are the same for each. No caller-id Display.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide