Callmanager 6.1.2 and Callmanager 8.62a

[patcbr600]

Hi all,

Hi have a CUCM cluster with version 6.1.2 with a ICT trunk to a CUCM 8.62a, i'm not able to place call betwen the two cluster, i have signalling but when i try to anwser the call is disconnected. After seeing the traces we found that CUCM 6.1.2 is sending a release complete and in the traces from 8.62a we see the folowing incoming msg:

18:12:49.393 |ViprUtils: Number has no +, not a valid E164 [57174]|1,100,150,1.5702^172.17.16.3^*

Since CUCM 6.1.2 does not support the + digit how is giving this error ?

Thanks

patcbr600

[Jaime Valencia]

You're configuring a "regular" ICT between them right?? not selecting any special use on 8.6.

If signaling works fine (phone rings) the I'd suspect a codec issue.

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk