Just wondering if anyone else has come across this issue.
We were migrating from a 2960S switch to a CBS350 switch. They have data VLAN 10 and VOIP VLAN 100.
We tried with one user phone migrated and the VOIP server, VOIP server on a port which is 'switch port access vlan 100'. Configured the same on both switches.
The phone will get an IP, but not register for voice services. If I move the VOIP server back to its original VLAN 100 port on the 2960S it all works fine. So I know VLAN 100 is propogating OK between switches via the 1111-8P router. Even if I put the VOIP server into VLAN 100 on the 1111-8P I get the same result.
Not sure if we need to leave it a bit longer, probably only left it for 5 minutes. But it does work as sonn as the VOIP server is pu tback into the 2960S
VOIP config from the CBS350
interface GigabitEthernet15
storm-control broadcast level 10
storm-control multicast level 10
port security max 10
port security mode max-addresses
port security discard trap 60
spanning-tree portfast
spanning-tree bpduguard enable
switchport mode trunk
switchport access vlan 10
switchport trunk native vlan 10
switchport trunk allowed vlan 1,10,100
macro description "ip_phone "
voice vlan enable
macro auto smartport type ip_phone
OUI added for Yealink phones
voice vlan id 100
voice vlan state oui-enabled
voice vlan oui-table add 0001e3 Siemens_AG_phone
voice vlan oui-table add 00036b Cisco_phone
voice vlan oui-table add 00096e Avaya
voice vlan oui-table add 000fe2 H3C_Aolynk
voice vlan oui-table add 001565 Yealink
voice vlan oui-table add 0060b9 Philips_and_NEC_AG_phone
voice vlan oui-table add 00d01e Pingtel_phone
voice vlan oui-table add 00e075 Polycom/Veritel_phone
voice vlan oui-table add 00e0bb 3Com_phone
VOIP device interface
interface GigabitEthernet2
description VOIP
switchport access vlan 100
