10-17-2010 04:55 AM - edited 03-16-2019 01:23 AM
I have 28xx router with VWIC2-2MFT-T1/E1 card
I want to choose specific timeslot for specific destination-pattern?
Also I want reverse of it; forwarding incoming-call from specific timeslot?
Possible?
Blew is my config?
controller E1 0/2/0
pri-group timeslots 1-6,16
!
interface Serial0/2/0:15
no ip address
encapsulation hdlc
isdn switch-type primary-net5
isdn incoming-voice voice
isdn sending-complete
no cdp enable
!
voice-port 0/2/0:15
!
dial-peer voice 54 pots
destination-pattern 888...
port 0/2/0:15
no sip-register
10-17-2010 07:30 AM
I want to choose specific timeslot for specific destination-pattern?
Why ?
Also I want reverse of it; forwarding incoming-call from specific timeslot?
Possible?
No.
10-17-2010 08:26 AM
GSM gateway is connected to
On each slot there is a special sim-card
I want to determine firstly which time-slot; ie which sim card the call goes out.
Thanks
10-17-2010 08:30 AM
AFAIK, you cannot do this. Only thing that you can do is busy out certain timeslots/channels.
Thanks,
Pashmeen Mistry
10-17-2010 09:28 AM
Under E1 controller, configure trunk-groups with ID and timeslot(s) desired.
In dial-peers, refer to said trunkgroup instead of port.
Of course, you cannot have control on incoming channel, but you can discern on which trunk-group the call comes from, and use translation-profile and rule for special routing.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: