Cisco 7975G loads "term75.default.loads" only

[ondrej.dobrusky]

Hi,

I've got 2 7975G phones. I've tried to switch them to SIP image SIP75.8-5-2SR1S. The first one without any problem, the second failed. I've made the factory reset by 1233456789*0# (3491672850*# as well), phone went to reset correctly (amber, then red lights), then I could see in the log that the IP was acquired correctly, then I saw the TFTP activity when the phone requested twice "term75.default.loads" (picture)

The phone itself activity was as follows:

- display backlit ON/OFF without any text on the display then

- 3 left down corner buttons (headset, mic mute, speaker) flashed once then

- first line button flashed once in amber light then no phone activity

Any ideas?

Thanks Ondrej

[paolo bevilacqua]

Try another, older firmware version.

[ondrej.dobrusky]

Thanks a lot. I've tried SCCP75.8-3-3S and the phone came back to life.

[paolo bevilacqua]

Good, Thanks for the nice rating and good luck!