cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
232
Views
0
Helpful
2
Replies
keith Kress
Beginner

Cisco UC520 CME Back light settings

Hello all

New to Cisco here and struggling to figure out back light settings for one single 7970 phone.

No matter what commands i try on CLI the phone still seems to follow a schedule.

What i am trying to achieve is the phone active and backlit 24/7

no matter where i look it seems articles point to settings up a schedule.

can anyone point me in the right direction of the commands to enable the phone to be backlit and active 24/7?

any help is appreciated thank you

2 REPLIES 2
Sasikumar Divvela
Cisco Employee

Below thread explains the back light behavior ( it is old not sure how much it can help). You can give a try using "backlightIdleTimeout" parameter.

https://supportforums.cisco.com/document/34946/configuring-backlight-behavior-cisco-ip-phones

Thank you for the reply and link sasikumar, I did try that article beforehand but still to no avail, the single 7961 still is following a schedule. Ive rebooted and factory reset phone and reset CNF files but still cannot get the phone to stay on 24/7

Content for Community-Ad

Spotlight Awards 2021