CME Conferencing

[JustForVoice_2]

Hi all,

Is there any way to configure software conference bridge in CME rather than hardware, because I do not have enough PVDMs?

Regards,

[nitsinha · Accepted solution]

You can only have a software based 3 party ad-hoc conferencing(multi-party not supported on software based conferencing, you will need PVDM's for that). Check the following doc

http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/admin/configuration/guide/cmeconf.html#wp1010534

Hope that helps

Regards

Nitesh

PS: Pl rate helpful posts

[JustForVoice_2]

Thnak you for your reply