03-18-2018 03:55 AM - edited 03-17-2019 12:26 PM
Hello, I am having CME 11.5 on router 2911
when I write any debug command to examine a call ,it says that the debug is on but there is nothing appear although the call is operating and changes occur
What shall I do ?
Solved! Go to Solution.
03-18-2018 04:56 AM
Issue "logging monitor" at global configuration mode.
03-18-2018 04:14 AM
If you have used telnet/ssh to login to the device, you need issue "terminal monitor" in privileged more; this command is not needed when you connect through console.
Alternatively you can use "logging buffered" to write debug output to local buffer and later view it with "show logging".
03-18-2018 04:24 AM
I did term mon but nothing appears
I want to see that real time, Is there a solution ?
03-18-2018 04:27 AM
If "term mon" is open, and you simply issue "conf t" and then "exit", do you see anything on the screen? How have you connected to the device?
03-18-2018 04:32 AM
CME#conf t
Enter configuration commands, one per line. End with CNTL/Z.
CME(config)#exit
I access it using ssh
03-18-2018 04:56 AM
Issue "logging monitor" at global configuration mode.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide