CME hunt group loop

[columoconnor]

I have CME 7.0 and a hunt group with two members in the list

Is the a way to make the group keep cycling so that it is always ringing....dont want call to get to voicemail...

thanks

Colum

[Ayodeji Okanlawon]

Hi,

Give this a go..

ephone-hunt 1

pilot 5000

list 1000, 1001, 1003

final 5000

That way after the first 3 numbers ring, then it should go back to the hunt-pilot

[kelvin.blair]

Just a friendly FYI.. With CME 7.0 you can do call blast out of the box. This way all phones in the list ring at the same time. As long as you do not specify a timeout value the call should keep ringing the hunt group.

http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/admin/configuration/guide/cmecover.html#wp1145800

[columoconnor]

I would not take no value in the timeout

thanks for the info on the callblast

[columoconnor]

It would not allow me to point the final to the hunt list

thanks

[kelvin.blair]

Then create a ephone_DN that forwards back to the huntlist..

[Ayodeji Okanlawon]

Just Like Kevin said, do the following:

ephone-dn xxxx

CFA 5000 (whatever your hunt pilot number is)

then configure your hunt list final to point to ephone-dn xxxx