We have a hunt group on callmanager 9.1. We also have SRST. I have been trawling for information regarding how to have this hunt group in CMESRST.
Here is the relevant info in telephony service (not call-manager-fallback)
Version 8.6
protocol mode default
ip source-address 192.168.1.1 port 2000
max-ephones 10
max-dn 20
hunt-group report delay 1 hours
hunt-group logout DND
max-redirect 10
I also created a voice hunt group
voice hunt-group 1 paralell
list 100,101,102,103
Pilot 199
Have also added the following global command
dial-peer hunt 2
When we do a failover test, the phones, go into CME mode ok. The DDI's ring them directly ok. but the hunt group, will only ring one of the phones within that hunt group and when it goes unanswered it hits the generic vociemail anouncement when no mailbox is associated.
Then when we failback, it would seem that the hunt group on the CMe router is still being used, rather than the Callmanger one.
Am I misisng something?