02-24-2010 04:07 PM - edited 03-15-2019 09:32 PM
Ok need to verify this one thanks..
Setup - CUCM 6.1 at Main Site. 2811 gateway (1 x 30 channel pri) at remote site. Link between both is small mpls pipe.
Remote site want to do conferencing but not use bandwidth across the Wan.
Can i setup the 2811 as a hardware resource for the remote site so that the 2811 gateway uses its dsp resources to handle the conf call.
If so how many conf calls can i do maxmum. I read that i can do 6 per bridge. So is that 6 max per conf call?
Anything else i need to be aware of for this?
Thanks,
Taff
02-24-2010 05:48 PM
The best practice is exactly that, resources as close as possible to the ones who will use them.
Just configure the MRGLs properly and they will use their resources when pressing conference or doing meet-me
I already covered all the "how many and how much" last week on this post
https://supportforums.cisco.com/message/3022308#3022308
It's exactly the same info you can use.
HTH
java
If this helps, please rate
www.cisco.com/go/pdihelpdesk
02-24-2010 06:07 PM
Fantastic! Thanks..
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide