Hi
I have a linksys 2102 that i have configured in CCM 6.1 as a 3rd party SIP device, it all regsiteres fine, i have an analogue phone plugged into port 1, and that rings and all is great, but i want to plug a bell into port 2 on the linksys 2101, but do not know to make the 2nd port active on the linksys and then to configure it on the CCM?
I have tried configuring like an ATA and swapping the MAC address around but it didnt like that, what i want to happen is for the the Analogue phone and bell to have the same number as well.
anyone got any ideas?
Thanks
Ash