cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
729
Views
0
Helpful
3
Replies

CUCM 6.0.1.3000-7 replication issue

Bright Adjarho
Level 1
Level 1

Hello Everyone,

I have two callmanager(Publisher & Subscriber) which crashed. I have installed the applications on new servers. Upon restore of the backup configurations to these new servers, I observe that it does not failover to the subscriber. I further noticed that the replcation state of the subscriber is 3 while that of the publisher is 2, which is good. Also, when i issue the command utils dbreplcation status on the subsciber it gives an error "error 11 returned in line 8060".

Please i need your help. Thank you in anticipation

3 Replies 3

ronpatel
Level 8
Level 8

Hi

What is the status of licenses in CUCM cluster.

Regards

Ronak Patel

Regards Ronak Patel Rate all helpful post by clicking stars below the answer.

Hi Ronak,

After the restore I noticed a carry over of the older licenses to the new server. I deleted these licenses leaving the license sent by cisco for the new server. The issue still persisted.

Thanks

moataz_mamdouh
Level 1
Level 1

have you tried the setps in the below link

https://supportforums.cisco.com/docs/DOC-13672