07-16-2010 08:42 PM - edited 03-15-2019 11:46 PM
Hi all I have CUCM 7
I used Cisoc OS Administratrtion, Settings>NTP Servers.
and I added the server which is cisco router.
but if ssh the serve and use the command:
utils ntp status , I can find the the server Synchronized for local not for NTP.
ntpd (pid 29169) is running...
remote refid st t when poll reach delay offset jitter
==============================================================================
*127.127.1.0 LOCAL(0) 10 l 14 64 77 0.000 0.000 0.002
10.10.10.254 CHU_AUDIO(1) 9 u 21 64 77 0.974 1153882 115118.
synchronised to local net at stratum 11
time correct to within 199 ms
polling server every 64 s
Current time in UTC is : Sun Jul 18 03:08:08 UTC 2010
==================================================================================================
==================================================================================================
in the router I added the following configuration:
ntp source FastEthernet2/0
ntp master 9
I also tried to change the Stratum number but no luck
any help please and thanks in advanced.
07-16-2010 09:18 PM
Is this VMWare or hardware server?
Hailey
07-16-2010 09:34 PM
VMware
I am testing it before doing it in customer site
07-16-2010 09:38 PM
What version of CUCM and what VMWare product are you using?
I've seen some inconsistencies in syncing with NTP when using VMWare in my lab. I've had one VM build sync with 28XX series router upon build without issue and another fail. However, I had almost no issues syncing to a domain controller (AD)...just tested for the sake of ruling out issues.
Hailey
Please rate helpful posts!
07-16-2010 10:06 PM
I am using CUCM 7.0.1.11000-2
and VMWare Work station 6
thank you for your help
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide