Are you able to post a configuration (removing usernames/passwords and public IPs if present) so that we could see what the gateway config looks like? This could be related to the calling party name/number not coming in to the gateway from CUCM as well, you may need to run some debugs during a test call to see if the information is making it to the gateway.
SIP is easier to make redundant. If there is more than one physical cable to the provider, then SIP can be reserved in three ways at L2, it's the Portchannel, STP and the Fex link, the same as RTG from Juniper. CUBE routers can also be reserved for ...
b+s brings Lightning to the forefront of the Salesforce Experience this summer by adding the ability to route and report on Salesforce Omni-Channel interactions.
b+s continues a product strategy of providing access to the full suite of native Sales...
11. September 2018 | Happy Landings | Frankfurt DE
Chatten Sie schon oder telefonieren Sie noch? Die digitale Kundenreise bringt den Chat-Kanal mit künstlicher Intelligenz in eine prominente Position. Nehmen Sie teil am Flug durch die Möglichkeiten des...
Collaboration Product and architecture introduction-CUCM Part(7/30)
A system has a 2 way divisible room with two SX80s. When the rooms are combined, only one codec will be used. User does not want a notification message displayed on the secondary Touch10.
Is there a method to lockout control of a Touch10 to pre...