10-25-2007 03:00 AM - edited 03-15-2019 07:01 AM
Hi,
I currently have the following scenario. AVoIP network based on the CCM5.x and Cisco SCCP Phones, a Cisco 2811 working has a gateway. The gateway is connected to the PABX via BRI. The Phone numbers on the VoIP phones are 3.... and the phone numbers on the PABX are 2.. and 4.. I want to be able to route calls between phones on the PABX and on the VoIP network and vice versa. The PABX is configured to redirect all digits starting with 3 to the BRI connected to the Gateway.
Do I have to configure dial peer in the gateway? What do I have to do in the callmanager? I already have search a lot, but have not found a simple solution.
I have attached the Gateway configuration.
Can anyone help me please?
André Santos
10-25-2007 08:12 AM
You need to be more clear in the end if it is only on-net calls you should stick with CallManager but if it is Off-net calls then you should be configuring Gateway. So be more specific what you have success and where you have failure.
Hope it helps.
CSB.
10-26-2007 02:09 AM
Hi,
Currently I have the situation that you can see of the picture. I can only make calls inside the voip. I can't make call between the PABX and the Voip. The only thing i have accomplished so far is to register the MGCP gateway with the call manager. I dont know how to make dial plans, for the pabx and ccm to be able to make call to each other
André Santos
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide