cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1096
Views
5
Helpful
5
Replies

Explanation about command (show power inline)

Faresnani
Level 1
Level 1

under the output of the command ( show power inline ) 

 

what is the explanation about this output?

 

Ieee PD 

 

and what mean pair status is 

Short/ Impedance Mism ?

 

*SEE THE ATTACHMENT*

5 Replies 5

Leo Laohoo
Hall of Fame
Hall of Fame

The PED is pulling power.  That is it. 

No way to determine if the PED is booting up or crashing.  

Try doing a TDR.

Leo Laohoo
Hall of Fame
Hall of Fame

@Faresnani wrote:

under the output of the command ( show power inline ) 

and what mean pair status is 

Short/ Impedance Mism ?


I want to see the complete output to the command "sh cable tdr interface Gi 1/0/23". 

NOTE:  Do not post screenshots.

Attached 

Is the PED connected using a cross-over cable? 

And only two pairs are used?

https://ripplesinharmony.wordpress.com/2016/11/08/cciew-2-4-configure-and-troubleshoot-poe-for-aps/

show power inline 

ON meaning the PoE device is plug 
Device IEEE PD it use standard as show below
Class is 3 
Max is 15.4 "15.4 according to standard IEEE 802.3af the max power is 15.4"
Power  is consumption of Power by device
blog_4oct2018_-_1_0.png