Fail to Chage the Interdigit Timeout Value in Cisco Gateway

[Luis Manuel Orozco]

Hello Everybody

I have this call flow:

PSTN (FXO) --> TCL File | Gw (H323) --> CUCM --> IP Phone

I have next Dial-peer in Gateway whith 9T pattern:

dial-peer voice 101 voip
 translation-profile outgoing test
 destination-pattern .T
 session target ipv4:10.1.1.12
 dtmf-relay h245-alphanumeric
 no vad

Please your help to reduce the interdigit timeout value because 10 seconds are too long.

I have tried this:

In the voice port:

voice-port 0/1/0
 timeouts interdigit 2

Under Telephony Service:

telephony-service
 timeouts interdigit 2

Under H323:

h323
  h225 timeout t302 2

No option worked. Some suggestion??

Thanks in advance!

[ogencheva]

Hello there. I just ran into the same issue on 3945E running 154-3.M4 code. I have opened a Cisco case, but not getting anywhere with it yet.

[Carlo Poggiarelli]

Hi.

Are you also using a TCL script?

please post your config and your call flow

Thanks

Regards

Carlo

[ogencheva]

Thank you for your note. I got my issue resolved. There were not a TCL script involved. I was testing a SRST setup and was trying to change interdigit timeout with  timeouts interdigit command under voice-port with no affect. The actual command that changes it for eFXS ports (phones registered to SRST gateway) is timeouts interdigit  command under call-manager-fallback.