07-01-2011 06:07 AM - edited 03-16-2019 05:44 AM
Hi All,
Are there any special steps to configure a fractional T1 or E1 for a MGCP Gateway
on the CUCM Gateway config page?
Let`s say where you only want to use/configure channels 1-12?
Any assistance will be greatly appreciated...
Many thanks...
KingofKingz
07-01-2011 06:27 AM
You need to use the service parameter "Change B-Channel Maintenance Status" to busy out the unused channels from CCM .
Even if this is possible you need to be aware before doing so that THIS IS NOT SUPPORTED BY CISCO.
If you want a supported method then you need to switch to H323
HTH
java
If this helps, please rate
www.cisco.com/go/pdihelpdesk
07-01-2011 06:39 AM
Hi,
I am sending you a link that will help you to busy out ISDN B channels.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide