How to verify DSP's physical location on Gateway

[dsusaina]

"show inventory raw / Diag " provides output of the DSP's location in the device like below,

NAME: "PVDM Slot :1", DESCR: "C2801 DaughterCard Slot"

PID:                   , VID:    , SN:

NAME: "PVDM 1", DESCR: "PVDMII DSP SIMM with Two DSPs"
PID: PVDM2-32          , VID: NA  , SN: FOCXXXXXXX

NAME: "DSP (C5510) 0/1/0", DESCR: "DSP (C5510)"
PID:                   , VID:    , SN:

NAME: "DSP (C5510) 0/1/1", DESCR: "DSP (C5510)"
PID:                   , VID:    , SN:

# How to indentify DSP which is located on Multiflex card [ Eg. VWIC2-1MFT-T1/E1] from the one inserted on Motherboard slot.

# Can I have / replace DSP which comes in Multiflex card ?

Thanks in advance for your support.

Regards,

Danial

[Chris Deren · Accepted solution]

VWIC cards have no DSPs built in, you need HDV card for external PVDMs, and "sh diag" shows if you have them properly via slot number.

Chris

[dsusaina]

Thankyou so much Chris,,