cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
135
Views
0
Helpful
2
Replies
Highlighted
Beginner

Inbound CLI

Does annybody know If it is possible to modify inbound CLI (calls from the PSTN).

I have Call Manager V4.1(3)

Telco upgraded our 30 Channel E1 circuits to support CLI type 5. This was required for outbound CLI changes.

However on inbound calls from the PSTN they can only present 10 digits. This means that the leading zero is being dropped. IE, When a call is made from the PSTN to an IPT Phone the CLI appears as 1315887000. However this should appear as 01315887000.

Debug ISDN Q931 on the MGCP gateway confirms the inbound CLI as 1315887000.

Any suggestions If it is possible to Prefix a leading Zero to the CLI?.

Thanks

Ian.

1 ACCEPTED SOLUTION

Accepted Solutions
Enthusiast

Re: Inbound CLI

Hi, take a look at the next url, you can see how to add a digit to the inbound call:

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a00805b6f33.shtml

Regards

Hope this helps, if so pls rate post

2 REPLIES
Enthusiast

Re: Inbound CLI

Hi, take a look at the next url, you can see how to add a digit to the inbound call:

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a00805b6f33.shtml

Regards

Hope this helps, if so pls rate post

Beginner

Re: Inbound CLI

Thanks,

Problem sorted.

CreatePlease to create content
Ask the Expert- Webex Hybrid Services Solutions