Hi All,
We have purchase a device for mobile calls and it works with SIP protocol, our configuration is:
* CUCM 8.5
* Voice Gateway 3825 with IOS: c3825-adventerprisek9-mz.124-24.T6.bin
* Cisco Ip Phones registered in Callmanager with SCCP
* Eyebeam softphone registered in CallManager as a SIP Device.
On CUCM i have been configured only the route pattern.
The SIP connection to the device is in the gateway (See dial-peer 5000), this is the configuration of the gateway:
voice service voip
allow-connections h323 to h323
allow-connections h323 to sip
allow-connections sip to h323
allow-connections sip to sip
supplementary-service h450.12
no supplementary-service sip moved-temporarily
no supplementary-service sip refer
fax protocol cisco
h323
call start slow
sip
registrar server expires max 3600 min 3600
no update-callerid
voice class codec 1
codec preference 1 g729br8
codec preference 2 g729r8
codec preference 3 g711ulaw
codec preference 4 g711alaw
voice translation-rule 200
rule 1 /^9030/ //
voice translation-profile celular
translate called 200
***Incoming dial-peer from CUCM****
dial-peer voice 1000 voip
voice-class codec 1
incoming called-number 9030..........
*** Outgoing Dial-peer*****
dial-peer voice 5000 voip
description SALIDA Celular Celufijo DualSim
translation-profile outgoing celular
service session
destination-pattern 9030..........
voice-class codec 1
session protocol sipv2
session target ipv4:10.130.1.9
dtmf-relay sip-notify rtp-nte
Every time when try to call from IpCommunicator or another SCCP phone the call is dropped but when i call from Eyebeam softphone it works correctly.
Note: 10.130.1.4 --> Ip Address of CUCM
10.130.1.2 --> Ip Address of Voice Gateway.
10.130.1.9 --> Ip Address of YX Wireless Sip Device (thirt party device)
Attach you can find:
debug ccsip calls ( For both IpPhone SCCP and Eyebeam Sip Softphone)
debug voice ccapi inout ( For both IpPhone SCCP and Eyebeam Sip Softphone)
Any help will be appreciate.
Thanksss.
