11-08-2015 03:32 AM - edited 03-18-2019 11:41 AM
Which type of modules or cards required in the gateway to configure an inter-cluster trunk between two different clusters.
Solved! Go to Solution.
11-08-2015 04:00 AM
You don't need any special hardware. Just create ICT or SIP trunk between CUCM-A and CUCM-B with relevant dial plan configuration. Doing so, phones of both clusters will be able to call each other.
- Vivek
11-08-2015 03:37 AM
For inter-cluster trunk between two cluster, you don't need voice gateway in between. You can create directly between call managers of different clusters.
- Vivek
11-08-2015 03:45 AM
the scenario is like i have some phones for (X) enduser installed in a remote site and registered with the CUCM-A in their HQ - then , Another cluster for another enduser is configured on CUCM-B on that same remote location
they need these phones registered with CUCM-A to make internl calls (on-net or internal calls) to phones or extentions configured on the CUCM-B
what is required for that with respect to HW?
11-08-2015 04:00 AM
You don't need any special hardware. Just create ICT or SIP trunk between CUCM-A and CUCM-B with relevant dial plan configuration. Doing so, phones of both clusters will be able to call each other.
- Vivek
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide