Invisible Route Pattern

[townofnewmarket]

This one has me stumped!!

I have a building that needed an interface to overhead paging, so I used an ATA186 and wired into the paging system that way.  Users must pick up the phone and dial *1 to overhead page.  So my problem here is I would like to check this setup against another building I am trying to do the same thing in.  In CCM 4.1(3) I can find nothing under Route Patterns for *1.  The 2801 at the site is H323, again, nothing in the config under translation patterns for *1, and the 3560 that has the ATA of course has nothing for *1.  Yet it works, LOL!!!  Where would I find the *1 pattern and how it is setup?  This is so weird!

Thanks anyone.

[chris.warren · Accepted solution]

is it possilbe that it is a translation pattern? Check the Route Plan Report for anything starting with *1.

[townofnewmarket]

Thanks, that helped.  It was installed as a Directory Number.

Not sure of the benefit of that, but hey it works!