I have IP Communicator 8.6.2.0 running from CUCM 7.1.5.32900-2. I was wondering if there is a way of setting it up, as I can't find it anywhere, so that if I hold down on a number I get a continous touch tone. I have an emergency phone on campus that requires a long press of # for two seconds to disconnect after programming. I have setup a 7960 to do it but would like to do it without having to break out a second phone if I don't have to. If there is no way of switching this that is fine as well. I can hold down on a number on the number pad but it is not a continous tone, it is a stutter.