cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1026
Views
0
Helpful
3
Replies

IP Phone CP-7965G dhcp warning

Victor Bidnenko
Level 1
Level 1

Our 7965 phone constantly shows in console log dhcp warning:

2146: WRN 10:43:47.341105 DHCP: dhcpValidateIP(): invalid ip 0x0
2147: WRN 10:43:47.341806 DHCP: dhcpValidateIP(): invalid ip 0x0
2148: WRN 10:43:47.342036 DHCP: dhcpValidateIP(): invalid ip 0x0
2149: WRN 10:43:47.342163 DHCP: dhcpValidateIP(): invalid ip 0x0

Sometimes it gets stuck geting an ip but mostly it works fine. We have DAI \ IPSG \ DHCP-snooping configured on that port on switch. Also a PC is pluged into pc port of phone.

Port config:

 switchport access vlan XXX
 switchport mode access
 switchport port-security maximum 2
 switchport port-security
 switchport port-security violation restrict
 switchport port-security mac-address sticky
 switchport port-security mac-address sticky c860.00XX.XXXX
 switchport port-security mac-address sticky f029.XXXX.XXXX
 ip flow monitor FL-Monitor sampler XXXXXX input
 ip arp inspection limit rate 50
 storm-control broadcast level 1.50 1.00
 storm-control multicast level 10.00 2.00
 storm-control action trap
 ip verify source

SW config:

ip dhcp snooping vlan XXX,XXX,XXX,XXX,XXX
ip dhcp snooping information option allow-untrusted
no ip dhcp snooping information option
ip dhcp snooping
ip arp inspection vlan XXX,XXX,XXX,XXX,XXX
ip arp inspection validate src-mac ip

Is this a normal behavior or some misconfiguration on switch?

1 Accepted Solution

Accepted Solutions

Victor Bidnenko
Level 1
Level 1

DHCP-snooping was the problem. Did not solved the problem but used a workaround by setting the voice vlan config line to the port.

View solution in original post

3 Replies 3

Victor Bidnenko
Level 1
Level 1

DHCP-snooping was the problem. Did not solved the problem but used a workaround by setting the voice vlan config line to the port.

Dear
can you please explain how dhcp snooping was a problem

Actually no debug was taken, but it looks rather simple - two devices are inserted in one port (phone+pc). When pc is turned off it releases address and switch thinks no device have got an ip in dhcp dhcp database (actually the phone has but maybe its i bug or expected behaviour of switch). Adding a voice vlan with different vlan (i.e. pc - vlan 10, voice vlan 20) makes switch use different table for other vlan and thus no problem when pc is turned off.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: