10-19-2013 04:36 PM - edited 03-16-2019 07:59 PM
I just confiured my first CUCM7, I have my gateway setup (2621 with 2FXS and 2FXO). I am using MGCP, now I would like to use my IP phone to make a call, say my cell phone for testing purposes. On my gateway I have an RJ11 line going into my phone jack to 1/0/0 (FXO). How to I configure CUCM7 to allow me to make an outside the network call?
10-19-2013 04:55 PM
Hi Jonathan,
There is a good bit you will need to do on CUCM side. You will want to configure dial plan, add the gateway as MGCP gateway, create route patterns, route lists, route groups, etc. Best place for you to start probably is to review the admin and maintain and operate guides for cisco CUCM on cisco.com.
Sent from Cisco Technical Support iPad App
10-19-2013 10:05 PM
Hi
Please find the below links which will help you:-
http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a008017825e.shtml
http://www.valcom.com/techsupport/config-docs/Cisco%20UCM-FXO-MGCP%20Configuration%20Guide.pdf
Thank you
please rate all useful information
10-20-2013 08:59 AM
Jonathan,
Also for starters this is a very good resource.
I'm not trying to make any advertisement but it's one of the best entry level books on configuring CUCM that I have found so far.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide