Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am unable to receive calls to my IP phones when I dial my DIDs. I can make calls out just fine, just not sure why I can't call in. To test I use my cell phone to place a call to my DID (provided my flowroute) and I just get a disconnect tone a fe...
I can't seem to get my CME to route my incoming calls to my phones. I would like to have 1001 and 1002 both ring when the telephone # is dialed. Can you please help me figure out what is wrong? I can call out just fine, just not able to receive an...
I just installed CME 8 on my Cisco 2821 (C2800NM-IPVOICE-M), Version 12.4(3e)Trying to load my two 7975G's but I don't seem to have the firmware in the system and the phone just sits at a blank background. What have I done wrong? Here is my show fla...
I would like to be able to configure my IP phones to make and receive calls (outside my LAN). What is a cheap and easy way to do this? Add a vonage device, get a SIP trunk? Also would I need to configure my router as a gateway and install CME on i...
Below is my Home Network layout. I am having trouble pinging the 50.2.30.0 subnet. I created OSPF routes and I am able to ping from HomeLAN router to BackUpHomeLAN router. My problem is that I can not ping from my laptop connected on the 192.168.1...
