Hi,
I have followed your subsriptions regards Mobility but have not found anything similiar to my setup, also this is the first time. I have a customer in sweden with a
MEX solution. Basically the customer dont have any ip phones. What I am trying to do is to have incoming external calls from one e1 to hit end-user RDP(s) and then have a
remote-destination to a mobile phone cross another E1. the I have read the design guide but the remote-dest call dont even hit the second E1. I can munually dial
the mobile phones cross the second E1. Any experince to set up mobility with no ip phones involved? Any advice would be much apppriciated!
Note: There is a requirement to have RDP configured due to an integration of an Operator system, also there will be a CUMA intergartion later on
Thanks
Mattias