Multicast RTP to 7960G

[samer.sabeeh]

Hello all,

is

<CiscoIPPhoneExecute>

<ExecuteItem Priority="0" URL="RTPMRx:239.1.1.1:22224"/>

</CiscoIPPhoneExecute>

enough to make cisco 7960 join a multicast group and play the audio. it is working on 7970 i'm JMF to stream wav file and it work fine but never on 7960

after executing the XML service the phone turn on the speaker and off the mic but nothing else looking at web interface of the 7960 i see

Domain		snmpUDPDomain
Remote Address		/0
Local Address		/0
Sender Joins		0
Receiver Joins		9
Byes		8
Start Time		0
Row Status		Active

kindly advice

Thanks

[jaschulz]

Hello,

Just for starters the range and port you are using is fine. We would really need a capture to be able to tell what is going on. What firmware are you using on the 7960G? I would try it with the latest firmware. Sounds like they are going into 'receive state'(muted and speaker comes on). Maybe you need to send a volume option as well? Tough to tell without a capture though. One thing you could try also is using the edge port range like 20482.

[samer.sabeeh]

Thanks for your reply,

i change the port as suggested, and added the vol option

here is the FW info :

App Load ID		P00308010200
Boot Load ID		PC03C300
Version		8.1(2.0)
DSP		4.0(5.0)[A0]

attached the pcab file which is ran before starting the service and after quitting.

phone ip add 192.168.10.33

pc attached 192.168.30.25

multicast server 19.168.10.100

thanks