07-17-2012 03:28 AM - edited 03-16-2019 12:13 PM
Hi!
During the installation of the subject, I've got the following issue:
===========================================================
DDR2 Memory 2047 MB with ECC detected
Intel(R) Pentium(R) M processor 1.40GHz
BIOS ISE 6.00, Build date: 08/02/06
System Now Booting ...
<sniped>
Booting from secondary boot loader..., please wait.
[BOOT-ASM]
Please enter '***' to change boot configuration:
Unable to load image
Unable to boot image�
===========================================================
After the output above, the module is reloading (in a cycle).
Any ideas? I suppose there no CUSP image file is on the HDD. Or HDD is broken. Has anyone experienced the same problem?
wbr,
Serg
08-13-2012 07:37 AM
I am experiencing this problem after a power outage. How did you get past it?
04-17-2013 09:54 AM
As I remember, I just booted the system via tftp using helper file. Then I did the clean install.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide