no caller-id on mgcp with FXO ports

[abd88elhak]

hi
i'm using cucm 10.5 with cisco router version 15.0 as MGCP gateway
i'm facing a problem with fxo ports :no caller-id displayed even this option is enabled on cucm
regdas

[abd88elhak]

any hepl for this issue ????

[abd88elhak]

hi 

all incoming call via FXO pots display unknown caller id 

the option caller id is enabled 

[Abhay Singh Reyal]

Try below :- 

Go to the voice-port and run below command
timing guard-out 1000
- Do a shut no shut for the port

++++
Make a test call and collect the below debugs. Provide the calling and called number as well.

debug voice ccapi inout
Debug vpm signal
Debug voip vtsp all
debug mgcp packets

Also get the Show tech from the gateway.

Regards
Abhay Reyal

[amralrazzaz]

hi i have same problem and i did what u said then its unknown number again for the incoming calls

keep in ur mind that im using Vodafone sim card because mi dont have in my place landline infra ,so im using sim card installed inside primacell device and connected to FXO voice port  . vodafone card i thinkits already has CLID OPTION (telecommunications copmany)

[amralrazzaz]

hi i have same problem and i did what u said then its unknown number again for the incoming calls

keep in ur mind that im using Vodafone sim card because mi dont have in my place landline infra ,so im using sim card installed inside primacell device and connected to FXO voice port  . vodafone card i thinkits already has CLID OPTION (telecommunications copmany)

[Abhay Singh Reyal]

Share the exact call flow ? Is it for incoming or outbound call ?

Regards

Abhay Reyal