Hello all - not sure this is the right place for this, but will give it a go.
I have two Cisco 7945G phones I'm using with an open-source PBX. One phone provisions fine (E0:89:9D:94:60:18). The second one I'm stuck where I enter the MAC address. The MAC address for the second phone is: E0:88:9D:94:5D:EB
When I enter the MAC in my PBX application, it returns "String property is not MAC address".
Looking online at MAC vendor ID tools indicates Cisco for my first phone, but for the second phone (MAC above) the tools show "no vendor found".
Proof:
Any ideas? It does not look like I can change the MAC on the phone.
Thank you for your time!
