I need to page to a 2N SIP Speaker and several ephones all at once on a UC560 CME 8.6
I have the page group setup for the ephone and thats good to go.
I can't seem to get the 2N to register as a SIP device. I have it configured in the voice register dn and pool. Belows the SIP config I have. Please note that I do not have the Voice register pool 1 assigned a paging DN for testing.
voice register global
mode cme
source-address 192.168.0.25 port 5060
max-dn 5
max-pool 5
authenticate register
create profile sync 2444610541562842
!
voice register dn 1
number 890
name 890
no-reg
auto-answer
label Test
!
voice register pool 1
id mac 7C1E.B300.85D0
session-transport tcp
number 1 dn 1
dtmf-relay rtp-nte
no call-waiting
codec g711ulaw
With this setup, I am unable to dial 890 and get the SIP device. Any thoughts on why? As a side note, I can call the deivce just fine using a Dial-pper voip.
Thank you
Jason Ryan
