09-29-2009 03:53 AM - edited 03-18-2019 10:38 AM
Hi Guys,
i have a problem where i am getting white noise when setting up a conference call. This is intermittent and i have noticed it occurs when the G722 codec is advertised but then 5mins later when trying again it works fine but then the G711 is advertised....any ideas ?
Solved! Go to Solution.
09-29-2009 05:09 AM
Have you tried disabling advertise G722 codec.
We had a similar problem and it was related to us using both a software and hardware conference bridge.
09-29-2009 04:46 AM
Which type of CFB you are using,
what CUCM version?
Always using the same CFB ?
where is the physical locations of CFB?
how many CFB in MRGL ?
09-29-2009 05:01 AM
Hi,
The CFB is Cisco IOS Enhanced CFB, CUCM version is 6.1.3, the CFB is local to the site and there is only one CFB in the list.
09-29-2009 05:09 AM
Have you tried disabling advertise G722 codec.
We had a similar problem and it was related to us using both a software and hardware conference bridge.
09-29-2009 07:32 AM
Worked a charm thx.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide